GÜDE 40536, Руководство по эксплуатации

Страница: 7 / 11

7
4. The wood slipped by cutting
Motor gets excessively
hot
1. Excessive thrust of the saw
band
2. Excessive tension of V-belt
3. Teething too coarse
4. Teething too fine
5. The guide wheel is no set up
correctly
6. Wheels need oil
7. Excessive stress
1. Reduce the saw band tension
2. Reduce the V-belt tension
3. Use finer teething
4. Use coarser teething
5. Adjust
6. Lubricate
7. Reduce the thrust and speed
Wrong cut (inclined)
1. Excessive thrust
2. Guide bearings not set up
correctly
3. Wrong tension of the saw
band
4. Saw band blunt
5. Poor speed
6. Too much clearance of the
saw guide
7. Loosened guide square
8. The band does not pass
round the guide wheel
correctly
1. Reduce the thrust by increasing
the spring tension
2. Adjust the guide bearings. The
clearance not above 0.1 mm
3. Increase the saw band tension
with adjusting knob
4. Replace the band
5. Adjust the speed
6. Adjust the saw guide y
7. Tighten up
8. Adjust
Wrong cut (coarse)
1. Excessive thrust or speed
2. Teething too coarse
3. Saw band tension too loose
1. Reduce thrust/decelerate
2. Use finer teething
3. tighten up
Saw band gets skidding
1. Too much strain n
2. The band tension too high
4. Reduce thrust/decelerate
1. Reduce the band tension