2
List of Contents
Description
Page
Properties
2
General safety information
2
Technical data
3
Motor assembly
3
Band saw assembly
3
Band speed
3
Saw band replacement
4
Saw upper wheel alignment
4
Guide bearings set-up k
4
Saw band tension set-up
4
Operator instructions
5
Hints for cutting
5
Selection of saw band
5
Putting the saw in operation
5
Maintenance
5
Troubles, causes, troubleshooting
6
Technical drawing
8
List of spares
9
Wiring diagram
9
Declaration of Conformity
10
Properties
1. Band saw was developed especially for vertical and horizontal use.
2. There are 3 speeds on the machine to cut metal, plastic or wood.
3. The unit will turn off automatically when the material is cut through.
4. Division in grades is provided on the unit to facilitated angular cutting.
5. The machine run is very silent.
6. The machine is easy to transfer owing to the wheels.
General Safety Information
1. This unit has a three-conductor cable with an earth and should be connected to the earthed sockets
only. Connection without a ground conductor is not permitted as lives of operators may be
threatened.
2. Damaged or worn cables and other defective parts should be replaced immediately.
3. Be careful to have any protection devices fitted on.
4. Remove any tools after adjustment before switching the unit on.
5. Keep your workplace tidy, untidy workplace and worktables may result in accidents.
6.
Never use the electric tools in moist and wet surroundings
.
7. Wear protective goggles.
Wear a dustproof respirator at works generating dust
.
8. Take a good care of your machine. The saw should always be clean and the saw band sharp for
you to attain the best possible results and your work to be as safe as possible.
9. Unplug before any maintenance and replacement of tools.
10. Use the proper machine. Do not expect the machine to do a job it has not been built for.
11. Before plugging the machine in, make sure that the switch is in OFF position.
12. Keep children and unauthorised persons at a sufficient distance from your workplace.
13. The value of lighting of the workplace should be 300 LUX as a minimum
14. Never stand on the machine and never lean over it either
15. Pay a special attention to vertical cuts. Keep your hands off the saw band!
Содержание 40536
Страница 8: ...8 Technical Drawing...
