!
Installation
Step 6.
Door Arm, Bracket and Plate Installation:
Install the door mounting bracket in the centre and even, with the
top set of rollers on the door as illustrated Figure. 10A. (Fasteners
Supplied: 2 ea. Lag Screw. Connect the straight door arm section
(single hole section) to the trolley using a 8mm x 25.4mm Clevis
pin and clip. The door arm must pivot freely. Connect the two
Door arm pieces so that it leans toward the power unit as
illustrated fig. 10B. Do not install the door arm so that it is straight
up and down when the door is closed or the emergency release
will not function properly. Now attach Door Arm to Trolley using
8mm x 25.4mm Clevis pin and clip.
Step 7.
Tie a double overhand knot in one end of the Emergency Release
Rope and slip the other end through the Red Release Knob, the
Release Instruction Card and the hole at the end of the Release
Lever on the Trolley (Please take time now to read and familiarise
yourself with the instructions on the Emergency Release Label)
Figure 10C. Tie a second double overhand knot in the free end,
adjusting the Rope so that the Red Knob is 2M above the floor. If
the Rope must be cut, flame seal the cut end with a match or
lighter to prevent fraying or unraveling.
Figure 10C
Release
Knob
Double
Overhand
Knot
Double
Overhand
Knot
Release
Instruction
Card
Note:
The Emergency Release Mechanism is engaged by pulling
the Release Knob down and towards the door, allowing the Trolley
Mechanism to separate freeing the door. To re-engage simply
move the Emergency Release Mechanism Lever upwards and
operate the Opener using the push button or Transmitter. The two
parts will automatically reconnect.
Note:
This operation should be attempted only when the door is
fully closed. Disconnection when open or partially open can cause
the door to close quickly and cause personal injury or damage to
the door.
Use Manual Release Rope to Disengage Trolley Only. Do Not Use the Rope and Knob to
Pull the Door Open or Closed
Warning:
A Child Operating the Door Controls Risks Injury - Or Death to themself and to
others. Do not Allow Children to Operate Any Door Controls. Mount the Push Button at least
1.5 M from the floor out of reach of children
Warning:
Improper Door Operation can Cause Injury or Death. Caution Label Must Be
Mounted on Wall near The Push Button. All Warnings Should Be Strictly Adhered To.
11
Hex Bolts
and Nuts
(2)
Lag
Screw (2)
Curved
Hitch Pin
Clevis
Pin and
Door Arm
Door
Bracket at
Centre of
Door
Door Arm
Straight
Figure 10A
