G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
4
Maintenance, Cleaning, and Storage
If Diablo 2.0 Tie-Back SRL fails inspection in any way, immediately remove it from service, and contact
Guardian to inquire about its return or repair.
Cleaning after use is important for maintaining the safety and longevity of Diablo 2.0 Tie-Back SRL. Remove all
dirt, corrosives, and contaminants from Diablo 2.0 Tie-Back SRL before and after each use. If Diablo 2.0
Tie-Back SRL cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER
clean Diablo 2.0 Tie-Back SRL with corrosive substances.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals,
or other degrading elements.
Installation and Use
Diablo 2.0 Tie-Back SRL must NEVER be used in Leading Edge (LE) applications.
Maximum 2’ free fall.
ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces.
1. All components of the personal fall arrest system must be selected and deemed compatible with Diablo 2.0
Tie-Back SRL by a Competent Person.
!
WARNING
In tie-back applications, snap hook must
ONLY be attached to webbing below
shock pack. NEVER attach snap hook
between housing and shock pack.
Snap hook
attached to
webbing below
shock pack.
OK.
NEVER
attach
snap hook
between
housing and
shock pack.
4. For Dual-Leg Kit, only work with one leg attached, except
when transitioning between anchor points. When transitioning
between anchor points, first connect second leg to applicable
anchor point, then disconnect other leg from previous anchor
point prior to beginning any work; this ensures 100% tie-off is
maintained at all times.
For Dual-Leg Kit (Part #11095), assemble SRL according to instruction sheet provided with Dual SRL
Bracket (part # 11058).
- Tie-Back:
Wrap Diablo 2.0 Tie-Back SRL lifeline around selected structural anchor, and attach snap hook onto
webbing BELOW shock pack (NEVER attach snap hook between housing and shock pack). Attach Diablo 2.0
Tie-Back carabiner to applicable harness D-ring.
2. Ensure structural anchor to which Diablo 2.0 Tie-Back SRL is to be attached, and on which work is to be
performed, is free of all hazards, including, but not limited to, debris, rot, rust, sharp or abrasive edges and
surfaces, and hazardous materials.
- Standard:
Attach Diablo 2.0 Tie-Back SRL snap hook to harness
dorsal D-ring, and attach SRL housing to compatible overhead
anchorage connector with carabiner. Anchorage connector must
be sufficiently overhead such that no more than 2’ of free fall
may be experienced in the event of a fall.
3. Diablo 2.0 Tie-Back SRL may be used in either tie-back or standard applications. Adhere to the applicable
method of installation and use:
