22-9240rev2.0
Inovonics Wireless Receiver Installation Instructions
6 / 2009
© 2009 CSG Security Corporation / Société Sécurité CSG
Page
3
of 6
[email protected] +1 905.206.8434 | [email protected] +1 905.206.8436 | Fax: +1 905.629.4970
Guardall
5201 Explorer Drive, Mississauga, Ont., Canada.
L4W-4H1
www.guardall.com | +1 877.249.9993
Diagnostic LEDs
Yellow LED
Green LED
Condition
Description
0 to 9 pulses to
indicate module
serial number, 5
digit value.
For module
programming.
On for 1 second
per serial
number digit.
Module Serial
Five Number
display
When the board is first powered up, the serial number is displayed
in an encoded format. The number of times the yellow LED flashes
while the green LED is ON steady gives the digit value. E.g. green
on, count 3 flashes on yellow, green off, first digit is “3”. Green
turns on again, yellow flashes 9 times, green off, second digit is
“9”. Etc. etc. until the entire serial number is displayed, one digit at
a time. It takes several seconds to complete the entire process.
NOTE: “0” is indicated by the green LED turning on and the yellow
LED does not flash.
Off
Flashing slowly
All ok
System operating normally.
On Flashing
slowly
Receiver
Tamper
The receiver cover is removed and the tamper switch is active.
Flashing slowly
Flashing slowly
Receiver
Failure
The receiver board is not communicating properly with the
interface board. Check the condition of the four wire
interconnection between the two boards and check power.
Flashing fast,
alternating with the
green LED.
Flashing fast,
alternating with
the yellow LED.
The Module
serial number
is not
programmed.
The non-volatile module memory is not programmed or has failed.
If (re)programming fails, return the module to the supplier for a
replacement.
Decode, Transmit, Receive LEDs
The Decode LED flashes brightly as any RF data is being received from a transmitter sensor.
The Transmit LED flashes to acknowledge RF data being received from a transmitter sensor.
The Receive LED is not used.
Repeater Overview:
The repeater module is used to increase the range of transmitting and receiving signals.
The Repeater is the same plastic enclosure as the Wireless Receiver.
Follow the same General Information Notes as the Wireless Receiver.
Decode.
(Processing RF
DATA)
Tamper
Spring
(+)12V
(
-
)0V
Plast
ic
ba
s
e c
able
in
let
kn
oc
kout
s
Back knock
o
ut
Side
kn
ockout
RF Repeater Module
Insert a wire link
(short) in this block
to disable tamper.
Power Input
Current Rating
= 40mA
Reset
Button
This 7 pin plug not used.
Plug
Re-chargeable Stand-by Battery
(12 hr life span)
LEDs
Transmit DATA
Low S/B Battery
Main power on
Press to reinitialize Repeater if all power lost.
NOTE: Re-check the Repeater’s
programming to ensure it is correct.
