22-9240rev2.0
Inovonics Wireless Receiver Installation Instructions
6 / 2009
© 2009 CSG Security Corporation / Société Sécurité CSG
Page
2
of 6
[email protected] +1 905.206.8434 | [email protected] +1 905.206.8436 | Fax: +1 905.629.4970
Guardall
5201 Explorer Drive, Mississauga, Ont., Canada.
L4W-4H1
www.guardall.com | +1 877.249.9993
Receiver Overview
The layout of the North American and European wireless receivers is the same except that there are no Frequency Setting
jumper pins on the European version.
The Frequency Setting jumper pins on the North American version must be set the same as described for the North
American sensor transmitters.
Module Bus
(+)
1
2
V
(
-
)0
V
Data A
Data B
ye
llo
w
bl
ac
k
gr
ee
n
re
d
Module Bus
communications
indicator LED
XXXXX
5 digit serial number to program
in Module Programming
1
4
3
2
NOTE:
DO NOT
attempt to
jumper this pin block.
Damage may occur. It is for
the manufacturer’s use only.
Interface Board Tamper Spring
Tamper
Enable
Jumper
Interface Board
Decode LED
Diagnostic LEDs
1
4
3
2
Plastic base cable
inlet knockouts
Back knockout
Side knockout
See Module Notes
Yellow Green
Enable Jumper must be removed.
See module notes below.
Current
Rating:
110mA
Interconnection
TX
RX
Radio Board Tamper Spring
AUS
NZ
1 2 3
Frequency Setting
No Jumper Used = North America
Frequency: 902-928 MHz
Jumper IN pins 1 and 2 = Australia
(AU) Frequency: 915-918 MHz
Jumper IN pins 2 and 3 = New
Zealand (NZ) Frequency: 921-928
MHz
Radio Antennas
Radio Receiver Board
Transmit &
Receive
LEDs
Dimensions: 3&5/8" (92mm) x 6&½”
(165mm) x 1" (25mm) deep.
Environment:
0 to 60° C (32 to
140° F). Up to 95% relative
humidity (non-condensing).
See Module Notes
NOTE:
the
Receive
LED is
not
used.
Receiver Module Notes
Tamper Enable Jumper
Dual Tamper Detection:
While the module is de-powered, remove this jumper. When power is applied to the module,
both the Interface and Radio board tampers are active. With the jumper in, only the Radio board’s tamper is active.
