17
Technical data for 1 motor
Modell
24V
Push/pull force
300N / 300N
Opening width (adjustable)
500, 600mm
Rated voltage
24V =
Rated current consumption
1,0A
Run time (full load / 2/3-load)
13,1 mm/s
Duty ratio (power-on time)
30% (10min)
Ambient temperature
-5 up to +75°C
Protection class
IP32
Connecting cable
5x0,5 - length approx 5m
dimensions Height x Depth x Width
40 x 56 x 639 mm
Weight
Approx. 3,3 kg
The specifications stated in this table are not binding and may be changed without notice.
Caution!
9
Drives preset for tandem- / tridem-operation are supplied as set and may be installed as
master and slave set only.
9
With the programmed synchronisation of two or three drives, each drive must be mounted
and connected as specified on the programming label on the drive,.
9
e.g. with programmed tandem operation:
Drive set 1 drive 1 / Master
Drive set 1 drive 2 / Slave
with programmed tridem operation:
Drive
/
Master
Drive 2 / Slave 1
Drive 3 / Slave 2
Caution!
The integration of the drive(s) into a closing sequence control system ist possible with locking
drive ELTRAL VA25 or ELTRAL VA35 (for assembly and electrical connection see the locking
drive mounting instructions)
18
To determine the installation variant depending on the sash height, refer to the following table or the
charts in section 3:
Min. sash high
Installation method
Stroke 500mm
Stroke 600mm
Tilt window frame mounting
1000
1250
Tilt window sash mounting
1000
1250
Tilt window sash mounting
folding bracket
750 900
Tilt window sash mounting
long bracket
550 700
Top hung window frame
mounting
1100 1400
Roof window
1100
1400
⇐
Note!
Smaller sash heights
Please contact us if smaller sash heights are required.
2.2
Preparing to install
Danger!
Caution!
Incorrect use may cause injury to people and damage to property
Refer to the type label of the motor and the technical data in section "2.1" to
ensure that you have the correct motor for your installation situation.
9
Examine the delivered equipment immediately upon receipt and check it for transport damage.
Do not install the motor if it is damaged.
