9
Tools Needed
• Power Drill
• Open End Wrenches —
3
/
8
",
7
/
6
",
/
2
", and
9
/
6
"
•
3
/
8
" Drill Bit
• Hacksaw or Heavy Duty Bolt Cutters
• Small (Flat Bladed) Screwdriver
• Phillips Screwdriver
Dual Gate Opener Parts List
(continued)
Control Box and Electrical Components
Transformer (1)
Battery (1)
Control Box (1)
Warning Signs (2)
GTO Transmitter(1)
1.
KEEP CLEAR! Gate may move at any time.
2.
Do not allow children to operate gate or
play in gate area.
3.
This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
Receiver (1)
• Tape Measure
• Level
• Wire Strippers
• C-Clamps — small, medium, and large
• Center Punch
• An extra person will be helpful
YOU MAY ALSO NEED THESE ITEMS BEFORE YOU BEGIN THE INSTALLATION
(Some of these items can be found in the
Accessory Catalog
page 39):
• L
ow voltage wire
will be needed to run from the transformer to the control box; length depends upon the distance between
the transformer power supply and the control box. See
Powering the System
on page 2, and the
Accessory Catalog
.
• PVC conduit.
• If your gate is more than 000' away from an ac power source you will need to use at least 0 to 30 Watts of solar charging
power to trickle charge the battery. See the
Accessory Catalog
.
• If your fence post is made of wood and is less than 6" in diameter or 6" square, see page 2.
• If your fence post is larger than 6" in diameter you will need
threaded rods or carriage bolts longer than 8"
. See page 5.
• If you have thin walled tube or panel gates, see
Recommended
Reinforcement Examples
on page 2.
• Depending on the type of gate,
a horizontal cross member
or mounting plate may be needed
to mount the front of the
opener and gate bracket to the gate. See page , step 2; page 5, step 0.
• Surge protection for transformer.
• Some types of installations require U-Bolts.
• If the gate is a push-to-open refer to page 32.
• Additional washer or a metal plate may be needeed for wooden post.
• For Push-to-open applications, you'll need the push-to-open bracket 347 IH
• Low profile ground stop. See page 8, step 3.
