34
Step 3
Note which gate has reached the desired closed position
(typically it's the slave gate), program the closed limit setting by
pressing and holding the corresponding 'LEARN MAST LIMIT'
or 'LEARN SLV LIMIT' button for 5 seconds.
Step 4
Press the transmitter button and allow the gates to return to the
closed position. YOUR FIRST GATE’S OPEN POSITION
LIMIT IS NOW PROGRAMMED.
Step 5
Activate your openers again by pressing the entry transmitter
button. Your gates should now be moving from the closed
positions toward their open positions. The first gate will stop at
the spot you just programmed and the second gate will continue
to open until you press the transmitter button again. Press the
transmitter button when the second gate reaches the desired open
position. This step may be repeated until desired open position is
achieved. Once the desired OPEN position has been achieved,
proceed to step 6.
Step 6
Repeat step 3 for the other gate that has not been set in step 3.
Step 7
Press the transmitter button and allow the gates to return to the closed position. BOTH YOUR MASTER AND SLAVE
GATE’S OPEN POSITION LIMITS ARE NOW PROGRAMMED.
TESTING YOUR OPEN LIMIT SETTING:
Press your entry transmitter and allow your gates to open. If OPEN positions are not correct or need to be changed, you will
need to CLEAR your OPEN LIMIT settings and follow steps one () to seven (7) again.
CLEARING THE PROGRAMMED OPEN LIMIT SETTING:
If you make a mistake and set the limit at the wrong position – press your transmitter to return the gates to their closed
positions, then press and hold the 'LEARN MAST LIMIT' or 'LEARN SLV LIMIT' button for 5 seconds. This will clear the
memory for the open limit positions. Follow steps one () to seven (7) again.
1
2
3
4
O
N
D
IP
STATUS
LEARN RMT
LEARN
MAST LIMIT
LEARN
SLV LIMIT
S3
S4
S2
ART OFF
G OFF
PULL
EN DLY.
OFF
OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN
MAX
CLOSE TIME
STALL FORCE
Learn Master Limit
Button
Learn Slave Limit
Button
If your GTO/PRO SW-2502 Gate Opener is not operating properly, please follow the steps below:
. First use the procedures found in the
Troubleshooting Guide
(
see page 35
).
2. If you are unable to solve the problem, call the
GTO/PRO Service Department
at (800) 543-236, or (850) 575-444.
Refer to the serial number (located on the control box cover) and date of purchase when calling for assistance.
3. If repair or replacement of your gate opener is necessary, the Service Department will assign a
Return Goods
Authorization (RGA) number
to you for warranty repair.
4. Securely pack the component(s) authorized for return to the factory. Write the RGA number issued to you on the outside
of the package in
LARGE BOLD PRINT
. Ship the package(s) freight prepaid to:
GTO/PRO, 3121 Hartsfield Road, Tallahassee, Florida, USA 32303.
NOTE: Products returned to GTO/PRO without a Return Goods Authorization (RGA) number in LARGE
BOLD PRINT on the outside of the package
WILL NOT
be accepted. Also, items returned to GTO/PRO
freight collect
WILL NOT
be accepted.
Repair Service
The
GTO, Inc. Technical Service Department
is open
Monday – Friday 8:00
A.M.
– 7:00
P.M.
(Eastern Time)
-800-543-236 • FAX (850)575-8950
e-mail: [email protected]
