GTO 2002XLS, Руководство по установке

Страница: 32 / 44

22
GTO 2002XLS Instruction Manual © 01.12.12
NEVER USE TRANSFORMER AND SOLAR PANEL(S) AT THE SAME TIME!
It will damage the control board!
IMPORTANT INFORMATION ABOUT LOW VOLTAGE WIRE:
• The only wire acceptable for use with GTO products is 16 gauge stranded, low voltage, PVC sheathed
wire. This gauge enables the solar panel to provide an adequate charge through the control board to
the battery at distances up to 250'.
• DO NOT use telephone wire or solid wire.
Step 1
Make sure the power switch is OFF.
Step 2
Strip 3/16" off the ends of the low voltage wire and twist tightly. Attach these ends to the 14VAC OR SOLAR
terminals located on the terminal block. Be certain not to let the exposed wires touch each other!
Step 3
Insert one solar panel wire into a 14VAC
OR SOLAR terminal. Insert the other
solar panel wire into the remaining 14VAC
OR SOLAR terminal. The wires can be
connected to the 14VAC OR SOLAR
terminals regardless of color/polarity.
Step 4
Tighten set screws against exposed end of wires.
NOTE: For multiple panels, wire the panels in parallel
as shown in this diagram.
VAR6
BATT +
K3
K4
WHT
GRN
SECOND OPR
.
RED
BLK
14 VAC
OR
SOLAR
ON OFF
Low Voltage Wire
from Transformer
or Solar Panel
Solar Panel Instructions
ON/OFF
Switch
ON/OFF
VAR5
VAR6
K1
PF1
K2
BATT +
BATT –
K3
K4
VAR4
VAR3
VAR2
VAR1
MIN MAX OFF
JP1
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
G
TO Inc.
Tallahassee, FL
R4722
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
SFTY.
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
SECOND OPR
.
FIRST OPR
.
RED
BLK
14 VAC
OR
SOLAR
ON OFF
Low Voltage Wire from
Transformer or Solar
RED
RED
BLACK
BLACK
Solar Panels connect in PARALLEL
24/7 Troubleshooting Wizard:
http://support.gtoinc.com