GTO 2002XLS, Руководство по установке, Страница: 31 / 44

GTO 2002XLS Instruction Manual © 01.12.12
21
MIN
MAX OFF
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
FIRST Opener
JOG Buttons
SECOND Opener
JOG Buttons
SET LIMIT Button SET LIMIT Light
Step 1: Remove Push-To-Open Jumper
A. Make sure the control box power switch is OFF.
B. Use small pliers to remove the JUMPER for PUSH-TO-OPEN
applications.
C. Turn power switch ON. The control board is now configured
to push the gates open. (Keep the jumper, as it is necessary
if there is ever a need to convert the opener for Pull-To-
Open.)
Step 2: Set the Open Position Limit (Push-to-Open)
The CLOSED limit is when the openers are fully retracted and the
gates are in the closed position. The closed limit setting can only
be adjusted by moving the gate brackets.
To acheive the optimum open position, you
must adjust the OPEN Limit setting:
A. If not already ON slide the ON/OFF
switch on the Control Box to the ON
position and make sure the arms
are in the CLOSED POSITION (fully
retracted).
B. Press and HOLD the FIRST Opener
OPEN button on the control board and
be prepared to RELEASE the button
when the gate reaches the desired
open position/limit. Use the JOG OPEN
and CLOSE buttons to "fine tune" the
gate position if neccessary.
C. Press and HOLD the SECOND Opener OPEN button on the control board and be prepared to
RELEASE the button when the gates reached the desired open position/limit. Use the JOG OPEN
and CLOSE buttons to “fine tune” the gate position if neccessary.
D. NOTE: The opener arms must be extended more than 7 inches to set limits. With the gates in in the
desired open positions PRESS and HOLD the SET LIMIT button until the alarm and RED Light come
on. Then release the button.
E. NOTE: When the control box cover is removed the receiver range is reduced to less than 5 feet. Press
the transmitter button once and allow the gate to fully close. The alarm will beep once when the gates
reach the CLOSED LIMIT. This indicates the LIMITS for both arms are learned and stored in memory.
F. Press the transmitter button and allow the gates to fully open to verify that it stops at the desired
positions. Repeat Steps B – E if correction is needed.
Note: Must have a transmitter that operates the gate. If not, see Personal Transmitter Setting on page 19.
MIN
MAX OFF
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
Push-To-Open Jumper
Setting the Open Position Limit