GTM Professional GTS 1300, Руководство пользователя

Страница: 39 / 48

8 Troubleshooting
8.1 General troubleshooting procedure
1. Try to find a solution for the problem with the help of the troubleshooting table.
2. If you cannot find a solution for the problem, speak to your dealer. Refer to section
1.4 .
8.2 Troubleshooting table
Problem Possible cause Possible solution
The machine does not auto-
matically pull in the material.
The blades are worn. Do maintenance on the
blades. Refer to section
7.1
.
The diameter of the material
is too large.
Do not chip thick material.
Refer to section 9.2 .
The wood chips from the
output have different sizes.
The gap between the blade
and the counter blade is too
large.
Adjust the gap. Refer to sec-
tion
7.1.6
.
The engine does not start. The engine has a fault. Make sure that:
•
The engine switch is set
to the ON position.
• The panic bar is re-
leased. Refer to section
5.8
.
• The safety lock switches
on the input and the out-
put are activated.
• The rotor is not locked.
The fuel level is too low. Fill the fuel tank. Refer to
section 5.2 .
The fuel tap is closed. Open the fuel tap.
The oil level is too low (only
if the machine has an oil
sensor.)
Replace the engine oil. Re-
fer to section
6.7
.
The rotor has a blockage.
Remove the blockage. Refer
to section 7.3 .
There are unwanted objects
in the input, such as stones
or metal.
There is no output (wood
chips) from the machine.
The output has a blockage.
Troubleshooting
D09-GS13S50- 1 2 39