GTM Professional GTS 1300, Руководство пользователя

Страница: 26 / 48

6.3 Do a detection test of the output
Procedure
1. Remove the bolts (A) and the
washers (B).
2. Start the machine and let it run idle.
Refer to section
5.3
.
3. Do not put any material in the input.
4. Tilt the output (C) until the locking key
is removed from the safety lock switch
(D).
Caution: Make sure that
the machine fully stops.
5. The test is successful if the machine
stops.
6. Tilt the output back.
7. Install the bolts and washers.
6.4 Clean the machine
Caution:
Do not clean the machine with a high-pressure cleaner.
Procedure
1. Remove wood chips and dust from the machine. Use a soft brush.
6.5 Do a check of the tension of the belts
Preliminary requirements
• Wrench size 10
• Alignment ruler
A
B
C
D
Preventive maintenance
26 D09-GS13S50- 1 2