GTCO CalComp DrawingBoard VI, Руководство пользователя

Страница: 13 / 43

DrawingBoard VI 13
The following table lists the tablet options used by the pre-programmed setups.
Default Save 2 Save 3
Mode Run Track Point
Baud Rate 9600 9600 9600
Data Bits 8 8 7
Parity None Odd Even
Data Rate 125 pps 150 pps 125 pps
Resolution 1000 lpi 500 lpi 200 lpi
Output Format Format 23 Format 30 Format 0
Emulation GTCO TTech DP5
High Resolution
Binary
Summagraphics
MM 1201 Binary
CalComp 2000
ASCII
Selecting a Custom Setup
You can setup specific tablet options by turning different combinations of Configuration keys ON
or OFF. The available tablet options are listed below.
To setup the tablet:
1. Turn on Configuration Mode by clicking on the Config/Exit key.
2. Click on the Bank key where you need to work (A, B or C).
You can determine which bank you are in by placing the transducer over one of
the Bank keys. The Indicator light is on if the Bank is active.
3. Determine whether the Configuration keys are ON or OFF by placing the
transducer over each key. If the key is ON, the Indicator light is ON
4. Repeat steps 2 and 3 for the remaining Banks as required.
5. After you have completed your setup, save it by clicking on one of the Save
keys.