GTCO CalComp DrawingBoard VI, Руководство пользователя

Страница: 7 / 43

DrawingBoard VI 7
Transducer
Two types of transducers can be used with DrawingBoard VI: pens and cursors. Both are
available in corded and cordless versions. The corded transducers receive power from the
digitizer. Cordless transducers are powered by batteries. They will go into a battery-saving
Sleep Mode when no button has been pressed for one to five minutes, depending on the type
of transducer being used. To reactivate a sleeping transducer, press one of its buttons.
Cursors
The cursor is similar in appearance to a mouse, except that it has an attached lens with
crosshairs for highly accurate detail work. Cursors are available in 4 or 16 button models.
Pens
Each pen corded and cordless are similar in appearance to a ballpoint pen. The pen transducer
has three buttons, two on the side of the barrel and one in the pen tip.
Preparing the Large Format DrawingBoard VI
Mounting on a Stand
Visit our Website www.gtcocalcomp.com to see our Recommended Tilt Stand
(Versa Table)
Attaching the Accessory Tray or the Optional Plan Holder
Additional T-Nuts have been included in the perimeter mounting channels on the DrawingBoard
VI frame. You can position the Plan Holder or Accessory Tray where it is most convenient for
you by attaching it to any one of the available T-Nuts. The following instructions and the
graphic below detail the installation of the Accessory Tray.
Simply slide the Tray Rails into the channel and line up the hole in the tray with the hole in the
T-Nut. Tighten the Thumb Screw to secure the Accessory Tray.