GT POWER GT3600ES, Руководство по эксплуатации

Страница: 9 / 20

9
GT3600ES
Preparation before
Operating
Adding Engine Oil
Please add correct oil before starting the
generator.
Above 5
o
C - use SAE 30
Between 5
o
C to -15
o
C - use 10W-30
Oil Capacity - 600ml
NOTE: Improper treatment of
generator could damage it and
shorten its life. DO NOT attempt
crank or start the engine before it
has been properly serviced with the
recommended oil. This could result in
an engine failure.
• Place generator on a flat, level surface.
• Remove oil cap and dipstick. Wipe
dipstick clean.
• Slowly fill oil into engine through the oil
filter until it reaches the full mark on the
dipstick.
• Stop filling occasionally to check oil level.
Be careful do not over fill.
• Install oil fill cap and fasten the cap
properly.
• Check engine oil level before starting
each time thereafter.
Adding Fuel
DANGER: Never fill tank indoors.
Never fill fuel tank when engine is
running or hot. Turn generator engine
OFF and allow engine to cool entirely
before filling fuel tank. Avoid spilling
gasoline on HOT engine. Keep fuel
away from sparks, open flames,
pilot lights, heat, and other ignition
sources. DO NOT light a cigarette or
smoke when filling the fuel tank. Fuel
is highly FLAMMABLE and its vapors
are EXPLOSIVE.
• Use only regular UNLEADED gasoline.
Do not use any fuel with more than 10%
added ethanol, and never use E85 fuel.
• Do not mix oil with gasoline.
• Install fuel cap and wipe up any spilled
gasoline.
CAUTION: Do not overfill the fuel
tank. Allow space for fuel expansion.
IF the fuel tank is overfilled, fuel
can overflow onto a HOT engine and
cause FIRE or EXPLOSION. If fuel
spills, wait until it evaporates before
starting engine. Check fuel lines,
tank, cap and fittings frequently for
cracks or leaks. Replace if necessary.
IMPORTANT: It is important to prevent
gum deposits from forming in fuel
system parts such as the carburetor,
fuel hose or tank during storage.
Alcohol-blended fuels (called gasohol),
ethanol or methanol) can attract
moisture, which leads to separation
and formation of acids during storage.
Acidic gas can damage the fuel
system should be emptied before
storage for 30 days or longer. See the
“Storage” section. Never use engine or
carburetor cleaner products in the fuel
tank as permanent damage may occur.
1. Engine Switch
2. Muffler
3. AC Circuit Breaker
4. Oil Drain Plug
5. Oil Fill Cap/Dipstick
6. Spark Plug
7. Battery
8. Earth Terminal
9. Low Oil Warning Light
10. Air Cleaner
11. Fuel Valve
12. Choke Lever
13. Fuel Gauge
14. Fuel Tank Cap
15. Fuel Tank
16. Recoil Starter
17. 230V AC Receptacle