GT POWER GT3600ES, Руководство по эксплуатации

Страница: 16 / 20

GT3600ES
16
Spark Arrestor
• Shut off generator and allow the engine
and muffler to cool down completely
before servicing spark arrestor (located on
the back of the muffler).
• Remove the clamp and spark arrestor
screen.
• Clean the spark arrestor screen with a
small wire brush.
• Replace the spark arrestor if it is
damaged.
• Install the Spark arrestor reversely.
Service Air Filter
The engine will not run properly and may be
damaged if using a dirty air filter. Replace
the air filter once a year. Clean or replace
more often if operating under dusty condi-
tions.
• Remove air filter cover.
• Wash in soapy water. Squeeze filter dry in
a clean cloth (DO NOT TWIST).
• Clean air filter cover before re-installing it.
Valve Clearance
After the first 50 hours of operation, check
the valve clearance in the engine and adjust
if necessary.
IMPORTANT: If feeling uncomfortable
about doing this procedure or the proper
tools are not available, please take the
generator to the nearest service centre to
have the valve clearance adjusted. This
is a very important step to ensure long
life for the engine.
General
The generator should be started at least
once every seven days and be allowed to
run at least 30 minutes. If this cannot be
done and the unit must be stored for more
than 30 days, use the following information
as a guide to prepare it for storage.
DANGER: NEVER store engine with
fuel in tank indoors or in enclosed,
poorly ventilated areas where fumes
may reach an open flame, spark or
pilot light as on a furnace, water heater,
clothes dryer or other gas appliance.
CAUTION: Avoid spray from spark
plug holes when cranking engine.
DANGER: Drain fuel into approved
container outdoors, away from open
flame. Be sure engine is cool. Do not
smoke.
Other Storage Tips
• Do not store gasoline from one season to
another.
• Replace the gasoline can if it starts to rust.
Rust and/or dirt in the gasoline will cause
problems with the carburetor and fuel
system.