GT POWER GT3600ES, Руководство по эксплуатации

Страница: 12 / 20

GT3600ES
12
• When engine starts, move choke lever
to 1/2 “CHOKE” position till engine runs
smoothly and then fully into “RUN”
position. If engine falters, choke back to
1/2 “CHOKE” position till engine running
smoothly and then fully into “RUN”
position again. If battery is unavailable,
use manual starting instructions.
• If engine is choking and running move
choke lever to the “CHOKE” position and
repeat starting instructions.
WARNING: Starter cord kickback
(rapid retraction) will pull hand and arm
toward engine faster than you can let
go which could cause broken bones,
fractures, bruises, or sprains resulting
in serious injury. When starting engine,
pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
Never start or stop engine with
electrical devices plugged in and
turned on.
• If engine fails to start after 3 pulls, or if
unit shut down during operation, make
sure unit is on a level surface and check
for proper oil level in crankcase. This
unit is equipped with a low oil protection
device. Oil must be checked and at
proper level for engine to start and run.
• Contact the original equipment
manufacturer, retailer, or dealer to obtain
a spark arrester designed for the exhaust
system installed on this engine.
• Replacement parts must be the same
and installed in the same position as the
original parts
IMPORTANT: Do not overload the
generator. Also,do not overload
individual panel receptacles. These
outlets are protected against overload
with push-to-reset-type circuit breakers.
If amperage rating of any circuit
breaker is exceeded, that breaker
opens and electrical output to that
receptacle is lost.
Connecting Electrical Loads
• Let engine run till stable and warm up for
a few minutes after starting.
• Plug in and turn on the electrical loads.
• Add up the rated watts (or amps) of all
loads to be connected at one time. This
total should not be greater than (a) the
rated wattage/amperage capacity of the
generator or (b) circuit breaker rating of
the receptacle supplying the power.
For recoil start, firmly grasp the recoil handle
and pull slowly until increased resistance is
felt. Pull rapidly up and away.
WARNING: Exhaust heat/ gases could
ignite combustible, structures or damage
fuel tank causing a fire, resulting in death,
serious injury and/or property damage.
Contact with muffler area could cause
burn resulting in serious injury. DO NOT
touch hot part and AVOID hot exhaust
gases.Allow equipment to cool before
touching.
• Keep at least 5 feet (152 cm) of clearance
on all sides of generator including
overhead.