GSI Group PNEG-1451, Руководство по установке

Страница: 33 / 118

5. 2.66" Corrugated Commercial Hopper Tank 4-9 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 33
Vertical Supports
After all three (3) hoop assemblies are in place, attach the 48" vertical supports (A) from hoop assembly
to hoop assembly, as shown in
Figure 5N . This requires ten (10) supports, five (5) between each set of
hoops. The second set of vertical supports must be bent at the flat area to allow for the tapering of the
bottom hoop assembly. Use 5/16" x 3/4" bolts (unless otherwise noted) with the head of the bolt to the
inside of the safety cage.
Figure 5N Vertical Supports
32" and 48" Safety Cage
Attach the vertical support (A) pieces to the existing hoop halves using the 5/16" x 3/4" bolts and nuts (with
the heads on the inside of the cage). Fasten two (2) hoop halves together and bolt to other end of vertical
supports. Attach cage hoop brackets to ladder,
Refer to Figure 5K on Page 31 for proper attachment.
Once cage hoop brackets have been installed, attach cage hoop halves (B) and tighten bolts. Repeat
installation for each safety cage required.
Figure 5O 32" Safety Cage Figure 5P 48" Safety Cage
Ref # Part # Description
A LS-6713 Safety Cage 48" Vertical Supports
B
Use 5/16" x 1-1/4" bolts at hoop
assembly overlap.
Ref # Part # Description
A LS-6858 Safety Cage 32" Vertical Support
B LDR-4201 Safety Cage Hoop Half
Ref # Part # Description
A LS-6713 Safety Cage 48" Vertical Support
B LDR-4201 Safety Cage Hoop Half