Grundig GCA-C0335P, Руководство пользователя

Страница: 6 / 48

NOTE: DO NOT change the Swiftdome Camera’s Communication Switch factory default settings.
4.3. Communication Switch Setting
The analogue Dome Camera’s communication switches are specified in the table below.
RS-485 is the interface for communication between the Dome Camera and its control device. For this reason, the
RS-485 setup of the Dome Camera and the control device must be the same. The RS-485 default setting is half-
duplex (see the following diagram). Please do not change the default setting without the notice of a qualified
specialist or supplier. As for the switches SW 3 and SW 4, they are used for termination and Line Lock
adjustment respectively. The switch SW 5 is mainly used when users want to restore the camera to factory
default status; moreover, once a firmware upgrade was carried out, users need to reset switch SW 6 afterwards.
4.4. ID Configuration
Please change the analogue Dome Camera’s ID if there is more than one Dome Camera in the same network.
Use this switch to change your Swiftdome Camera’s ID by setting the 10-bit dip switch. For instance, if the
camera’s ID is 006, set the SW 8 and SW 9 to “ON”, the rest to “OFF,” as shown below.
For switch configuration details, please refer to the Switch Settings Index Table (Chapter 6) in this manual.
NOTE: No two Dome Cameras should be given the same ID, otherwise a communication conflict may occur.
4.5. Camera Control Protocol Setup
Define the protocol you are going to use based on the devices of your surveillance system. Generally, the use of
one protocol is recommended even if the devices are provided from different manufacturers. Please refer to the
table below for all supported protocols with their matching switch numbers and baud rate and choose a protocol
for your Swiftdome Camera.
Use the 6-bit dip switch (Camera Control Protocol Switch) to set your camera’s control protocol and its baud rate.
4 English