11
Revision date: 04.17.20
2-Layer Film Install
U-Channel (102197) — End Rafters
After attaching ribbon boards and baseboards (if used), attach u-channel to top of each end rafter using FA4482B Tek screws spaced at 12" on-center.
Complete these steps:
1. Beginning at top of ribbon board along
one side, attach the first section of 102197
u-channel using FA4482B Tek screws.
NOTE:
Align u-channel with center of end
rafter and install over and through the
installed flashing.
2. Continue to install u-channel up and over the
end rafter down to remaining ribbon board.
102197 Aluminum
U-Channel
FA4482B
Tek Screw
Baseboard
U-Channel
Ribbon Board
3. Cut additional sections of u-channel to
install below ribbon board down to ground
level or to top of baseboard.
4. Repeat for remaining end rafter.
5. Continue with next page.
U-Channel
Baseboard
U-Channel
U-Channel
Ribbon Board
