15
Revision date: 10.25.12
After the end panels and main cover are installed, the assembled
frame can be set on the base.
NOTE:
The assembled frame and cover are lightweight and easily
moved by wind. To prevent damage to the frame and to prevent
personal injury,
DO NOT attempt to set the frame on the base during
windy or stormy conditions.
Anchoring the base to the site: Your sales representative has
anchoring suggestions to help you anchor your cold frame in place.
Call 1-800-245-9881 to talk to a representative about the best way to
anchor your cold frame.
Continue with these steps:
1. With adequate assistance, lift and set the assembled frame onto
the recycled plastic lumber base. The short hinge pipes are set into
the slots of the base end boards.
2. Locate one (1) 104643 mid connector and secure it as shown
using screws (#FAF25P). See diagrams below.
NOTE:
It is best to install a few screws to secure the bracket and
then to check the operation of the cover
before
all screws are
installed. Adjust as needed.
3. Repeat the step for the remaining mid connector.
4. Check the operation of the main cover and adjust brackets
and reinstall screws if there is any interference with the cover
operation.
7
SET THE ASSEMBLED FRAME ONTO THE BASE
104643
Assembly Instructions
Frame may differ from actual frame.
Ground Level
Front
Back
