12
113463_64_65HBC Revision date: 08.27.19
End Panel Installation
3
END PANEL INSTALLATION
Gather parts:
• (2) End panels
• Fabric Clips: CC6213 (for 1.66" rafters)
• For One Panel: 1.315" Pipe: (3) 131S075 & (1) 131P0255
• (2) QH1330 brackets & FA4474B Tek screws
End panel installation typically occurs before stabilizer bar, cover, and baseboards (if
used) are installed. Use the information and photos that follow to install end panels.
ATTENTION:
During installation, do not stretch panel too tight. Doing so will make
Complete these steps:
1. Spread panel out at one end of frame.
Roof cover is shown rolled to
peak. Cover is installed later.
2. Assemble end panel conduit using the 1.315" pipe noted above,
secure each pipe joint with Tek screw, and tape over screw. Slide
conduit into pocket.
it difficult if not impossible to close panel once it is unzipped without damaging zippers. Test zippers a few times during installation to ensure these open and
close smoothly. Loosen panel slightly and reposition clips if needed to improve zipper operation.
NOTE:
When sliding conduit into panel pocket,
do not slide
conduit into door panel section of end panel
. Doing so will
prevent rolling door panel up when zippers are opened. Dashed
line shows conduit in panel pocket.
Conduit outside panel
pocket for this section.
conduit
Door Panel of End Panel
