25
GROWSPAN
™
COLD FRAMES & GREENHOUSES
Revision date: 05.08.18
CUT SHEETS: FRONT PANELS, "A" AND "B" PANELS
1-Front
2-Front
Sliding Door
Panels A & B
Read the instructions and use the diagrams
before
cutting and installing the panels.
REMOVE THE PROTECTIVE FILM.
DO NOT ALLOW THE PANELS TO REMAIN IN
DIRECT SUNLIGHT WITH THE PROTECTIVE
FILM STILL IN PLACE. DOING SO WILL MAKE
THE FILM DIFFICULT IF NOT IMPOSSIBLE TO
REMOVE.
DAMAGE TO PANELS MAY OCCUR IF
STACKED IN DIRECT SUNLIGHT. PROTECT
STACKED PANELS FROM DIRECT SUNLIGHT.
ATTENTION:
Install all UV-protected surfaces to the outside (toward the sun) of the cold frame.
Cut the panels as follows:
• Panel A and Panel B: one (1) 4' x 8' polycarbonate sheet
• Panels 1-Front, 2-Front, 1-Back, 2-Back, and Panel C: one (1) 4' x 8' polycarbonate sheet
• Panel D: one (1) 4' x 8' polycarbonate sheet (Part of this panel will remain in case a panel needs re-cut.)
40"
48"
13-1/2"
44-3/4"
48"
