GROWSPAN
™
COLD FRAMES & GREENHOUSES
12
Revision date: 05.08.18
NOTE:
The vertical profile where it meets the horizontal
profile of the ends can be cut at a slight angle to match
the angle of the upper profile if desired. See black
dashed line in the previous photo.
CUT AND ASSEMBLE THE POLYCARBONATE PANELS
(CONTINUED)
7. After attaching all main cold frame panels, continue
by assembling and installing the sliding panels for the
cover.
Horizontal profile
sections for the
front and back
run
to the edge of the
frame. See solid
lines and arrows
to the right.
Wafer-Head
Screw (#105116)
Edge of
Frame
Edge of Frame
Horizontal Profile
Dashed line shows the
edge of the panel
.
Vertical profile
sections run
between
the
horizontal lengths.
ASSEMBLE THE TWO (2) SLIDING PANELS FOR THE
COVER
Panel A and Panel B are assembled differently. Consult
the panel diagrams for each panel at the back of these
instructions for dimensions and additional information.
Assemble Panel A
1. Use the panel from Step 1 (previous procedure), the
panel diagram, and the diagram below to cut the first
profile section to the proper length.
2. Take the tube of silicone and apply a thin layer along
the edge as shown.
Profile runs parallel with the cells in the panel.
Panel will slide in this direction when installed. Handle
is attached to this section of profile.
3. Install profile flush to the ends of the panel. Consult the
diagrams for the proper position.
Cut and attach
this section of
profile first.
