7. Connect the RS485 connector onto the inverter. Make sure the connection
matched ('1' to '1', '2' to '2').
Type 2:
1. Please loosen four screws, take down the RS485 waterproof cover from inverter. If
you don't choose RS485 as communication method, keep it on the inverter.
2. Slightly loosen the swivel nut, remove the filler-plug from the M16 cable gland.
3. Make the cable through the hole of cable gland and put the cable into the RS485
terminals, fix all cables with screwdriver ('1'to'1', '3'to'3', '2' to the shielding layer
Information
Pull cables outwards to confirm whether they are installed firmly
4. Plug in two terminals. Cover the fix board.
Information
Tighten 4 pcs screws first, then tighten cable gland.
5. Tighten 4pcs screws and cable gland.
Note:
1) As to the connection between inverters, please refer to the following figure.
2) As to the connection between inverter and ShineWebBox (ShinePano), please
57
58
