13
4
INITIAL STEPS FOR INSTALLING YOUR DRYER
The following instructions will help guide you through the initial steps of setting up your dryer for use.
Please note that every section of this manual provides important information regarding the preparation and
use of your dryer, and it is important that you review this entire manual before proceeding with any
installation or use. More detailed instructions concerning electrical connections, gas connections, and
exhaust requirements are provided at other parts of this manual.
Choose a location with a solid floor for your dryer.
Place the dryer at least eighteen inches above the
floor for a garage installation. After placing the
dryer in the desired location, please make sure that
it has the required clearances shown below, and
sections on Exhaust and Maintenance requirements.
* Most installations require a minimum 5 1/2 in.
(14 cm) clearance behind the dryer for the exhaust
vent with elbow.
38,7
°±
(98,3 cm)
27
°±
(68,6 cm)
29,96
°±
(76,4 cm)
49,8
°±
(126,4 cm)
Level the d
the adjusting nuts
If the d
properly and the sensor will not be able to de tect
the dryness level accuratel
Adjust the le
Note
No other fuel-burning appliance shall be installed
in the same
This applies only
in a c loset.
WARNING
The applian ces are he avy.
Two or more people a re requi
or installing the appliance.
The re is a risk of serious back injury or other injuries.
Note
Those required minimum clearances
are set forth in the picture below. Please also keep the
following instructions in mind when installing in a
closet or recessed area:
Consider allowing additional clearance for
installation and servicing.
Wall, door and floor molding may force additional
clearances.
An additional inch of clearance is recommended to
minimize noise transfer .
Consider space needed for companion appliances.
For closet installations, the picture below shows the
minimum required ventilation openings for the door.
A louvered door with comparable ventilation openings
is also acceptable.
r
o
o
d
t
e
s
o
l
C
w
e
i
v
e
d
i
S
-t
e
s
o
l
C
ryer using the leveling legs and tighten
to hold them in place.
ryer is not level, the c lothes will not tumble
y.
veling legs carefully to avoid injury.
c loset as the drye r.
to dryers suitable for installation
red when moving
Closet-Front view
Stacking Kit view
All four legs should be placed firmly on a solid
and even floor.
STEP 1
Positioning the Dryer.
www.groupdynamics-laundry.com
Содержание SD205C
Страница 2: ...www groupdynamics laundry com sales groupdynamics lv ...
Страница 36: ...35 Component Test Procedure Check result Remark www groupdynamics laundry com sales groupdynamics lv ...
Страница 42: ...41 WARNING www groupdynamics laundry com sales groupdynamics lv ...
Страница 44: ...43 Test 2 Thermistor Test Measure with Power Off www groupdynamics laundry com sales groupdynamics lv ...
