Grossenbacher Systeme 50 81 379, Описание устройства

Страница: 25 / 55

E thernet P anel
Hardware EthernetPanel
© 2010 by Grossenbacher Systeme AG DVS 60646 V1.0 25
7 Mounting instructions
7.1 G
ENERAL MOUNTING INSTRUCTIONS
All EthernetPanel series devices are mounted from the front, i.e. in a control
panel. They are fastened from the rear with the supplied fixing frame and 4
securing nuts.
All EthernetPanel series devices can be operated up to a maximum ambient
temperature of 50°C (
Î Section 11). The ambient temperature stated
applies to the area 5cm above the device, if it is mounted vertically with
unimpeded air convection and a maximum operating height of 2000m above
sea level.
The device can be mounted in an enclosure if the ambient temperature is
taken into consideration. Provide a wall clearance of at least 50 mm on all
sides of the housing, so that sufficient air circulation is ensured. A minimum
clearance of 75 mm from active elements such as load current supply,
transformers etc. must be ensured.
Avoid the exposure of the flat screen to direct sunlight. The radiation from
the sun (UV component) reduces the lifespan of the LCD display.
The following must be ensured in order to prevent the
device from overheating during operation:
- The cooling slots must always be free in order to
ensure the proper cooling of the system.
- Avoid the exposure of the flat screen to direct
sunlight.
- The mounting angle must not exceed ± 35° from
the vertical
If these conditions cannot be met, the mounting of an
external fan is recommended.
7.2 M
OUNTING IN THE FRONT PANEL
- G
ENERAL
1. The front seal must be inlayed in the frontpanel slot and the two ends
must be justified at the lower side
2. Push the EthernetPanel from the front into the cutout of the front
panel.
3. Secure the device from the rear with the supplied fixing frame. For this
use the 4 securing nuts which should be tightened evenly from the rear
until the front frame is flush with the front panel all round.
Ensure that the seal is fitted correctly on the front panel.
For devices with a round seal the two ends must be at
the lower side of the device and should fit together
without a gap.
Avoid tightening torques of greater than 0.5 Nm as this
could otherwise damage the device.
The thickness of the front panel must not exceed 5 mm.
DVS 60646-V1.0