Grossenbacher Systeme 50 81 379, Описание устройства

Страница: 22 / 55

E thernet P anel
Hardware EthernetPanel
22 DVS 60646 V1.0 © 2010 by Grossenbacher Systeme AG
5.11 I
NSERTING
/ R
EMOVING THE
C
OMPACT
F
LASH
™
The EthernetPanel series devices use a CompactFlash™ card as mass
storage device. The CompactFlash™-Slot is placed on the upper side of the
dives. It is strongly recommened to use only CompactFlash™ cards
obtained from the original accessories.
The CompactFlash™ must only be fitted or removed
with the device power supply switched off.
Otherwise data can be lossed.
The device cannot run without a CompactFlash™ card.
Correct functioning of the device can only be ensured
by using CompactFlash™ cards obtained from the
original accessories.
5.12 I
NSERTING
/ R
EMOVING THE
SDCARD™
The EthernetPanel series devices use a SDCARD slot for removable mass
storage devices. SD and SDHC cards are supported. (s.a. accessories)
SDCARDs may be removed during operation. To avoid data loss it is
recommended to use the operating system functionality to replace the
removeable devices. (s.a. system description WindowsCE/XP)
5.13 E
XPANSION
PC/104-S
LOT
The EthernetPanels devices can carry one PC/104 module (e.g. Profibus
DP-Master/Slave or MPI) which must be inserted factory made. The PC/104
interface is compatible to standard 8-bit ISA-Bus, but has a limited
functionality. Only PC-104 modules out of the original accessory range can
be used. The following modules are supported:
Profibus DP (Master, Slave, MPI) no restrictions
2
nd
CAN interface no restrictions
4xRS232 mutual exlusive with Power Fail
functionality (see chapter 5.3)
The PC/104-module must be inserted factory made.
5.14 E
XPANSION
PC/104-S
LOT
Optinal a 2,5” Sata hard disk is available for the device. This option must be inserted factory made. The hard
disk can be installed instead of the PC104 module.
DVS 60646-V1.0