2
English
Under
Calibrate
in the chapter setting mode the faucet must to
be proportioned to the local circumstances.
• The display 100 °F must be synchronised with the measured
temperature.
• The minimum and maximum flow rate must be adjusted.
Thus changed the jet image.
Using the pre set panel
- Before using the pre set panel for the first time, it must
be connected to the operating panel in setting mode under
Wireless
.
- The programs can be customised or changed in setting
mode under
Preset
.
- The bars on the display illustrate the chronological
sequence of the relevant program.
Setting mode
Setting mode is activated as follows:
1. Switch on the faucet via the
button and set the
temperature to 91 °F using the button.
2. Press the buttons in a clockwise sequence:
3. When, after pressing for the third time, the
GROHE
Logo appears, confirm with the button.
Setting mode is now activated and
Menu
appears in the
display.
This is confirmed using the button on the operating panel.
Adjustment is made using the
buttons. End setting
mode by pressing the
button.
The following settings can be changed using the operating
panel:
Clock
(set time)
13:26
13:26
°C / °F
(temperature unit conversion)
°C
°F
Wireless
(establish connection with pre set panel)
Press any program icon on the pre set panel and hold
for at least 4 sec.
(numbers appear on the display if the connection
is successful)
Reset
(reset factory settings)
Factory set? No
Factory set? Yes
Saver
(time until screensaver appears)
5 sec
Versions
(show respective software version)
000
(operating
panel)
000 (function unit)
000 (pre set panel)
Visual
(set colour of the temperature arrows)
Red/Blue
Orange
Standby
(select screensaver)
Off GROHE 13:26
Contrast
(set background contrast)
12
Preset
(program pre set panel)
Resume
(time for pause mode)
60 sec
Protect
(time for safety shut-off)
60 sec
Max
(switching 109 °F stop on/off)
On
Off
The display flashes if 109 °F is exceeded.
Optimal
(define start temperature and volume rate)
First make settings in the
Calibrate
menu.
100 °F
Calibrate
(adjust mixer unit)
Swap Hot Cold Swap Cold Hot
(connections interchanged)
100 °F | 0
Volume Min | 1
Volume Max | 30
Maintenance
Inspect and clean all components and replace if necessary.
Disconnect voltage supply.
Shut off hot and cold water supply.
Disconnect all plug-in connectors
, see fig. [9].
I. Battery
, see fig. [10].
The battery must be replaced 10 years after commissioning
the fitting, at the latest.
II. Thermistor,
see fig. [11].
1. Disconnect plug-in connector (A).
2. Unscrew nut (B) and pull out thermistor (C).
III. Flow control (48 009)
,
see fold-out page I.
Install in reverse order.
Replacement parts
See fold-out page I (* = special accessories).
Disposal note
Dispose of batteries in accordance with national
regulations.
Hand washing
Face splashing
Teeth brushing
Memory button 1
Memory button 2
Section 1
Flow 0
Time 0
Temp 38.0
Volume 1
Section 2
. . . .
. . . .
Section 7
Section 1
. . . .
. . . .
. . . .
