OM-CC-E and C/2-E
11
Examples: 2 minutes = 00:02
(Just press 2).
1 hour and 30 minutes = 01:30
(Press 1, 3, and 0, or press 9,0
the timer will change to 1:30)
The colon [:] between the numbers on the time
display will blink and the generator will begin to
produce steam. The time will not count down
unless the
READY
light is lit.
NOTE
: You cannot change modes if the timer is
running.
8.
To Test Combo Mode Operation
, turn on the
power and clear any time from the timer display.
Press the
COMBO
touch pad. Set the
COOK
temperature to 300
o
F (150
o
C). The
WAIT
light
will come on. It will remain on while (1) the steam
generator fills with water and heats it to its
standby temperature and (2) the air heater raises
the air temperature to 300
o
F. Both actions should
be completed in about five minutes, starting with a
cold unit. When the set temperature is attained,
the
WAIT
light will go off, and the
READY
light
will come on.
NOTE:
The timer does not control the oven in
either the Combo or Oven Modes.
9.
To Test Oven Mode Operation
, turn on the
power and clear the Time/Status display. Press
the
OVEN
touch pad. Set the cook temperature
to 350
o
F (175
o
C). The
WAIT
light will come on.
Within six minutes from a cold start, the
WAIT
light should go out and the
READY
light should
come on. When that happens, turn the
COOK
temperature setting down to 320
o
F (160
o
C). The
HOT
light will come on. The heat-up times
provided above may vary slightly as a result of
voltage or water pressure differences.
10. To shut down the unit, switch off the power.
11. If your Convection Combo™ behaves as
described, the unit is functioning correctly, and is
ready for use.
OM-CC-E and C/2-E
11
Содержание Convection Combo C/2-E
Страница 9: ...OM CC E and C 2 E 9 Proper Drain Line Connections 2 in 50 mm OM CC E and C 2 E 9...
Страница 12: ...OM CC E and C 2 E 12 Standard Operating Controls OM CC E and C 2 E 12...
Страница 23: ...OM CC E and C 2 E 23 CC10 E Heater Schematic CC10 E Control Schematic Diagrams Schematics OM CC E and C 2 E 23...