Groen Convection Combo C/2-E, Руководство оператора

Страница: 14 / 26

OM-CC-E and C/2-E
14
3. Cooking Mode Selection
a. STEAM — Selects steamer operation
only.
b. COMBO — Selects superheated steam
and convection oven operation.
c. OVEN — Selects convection oven
operation only.
4. Power
The ON touch pad turns the unit on or off.
When power is on, the
ON
light just above the
touch pad is lit. Use of this pad does not
reset the controls. The unit will always come
on in the same mode it was in when shut
down.
5. Temperature (TEMP) Section
a. The Cook Display Window shows the
selected temperature in either Oven or
Combo Mode. It is blank in the Steamer
Mode or when the optional Hold Mode is
operational.
b. Turning the Temperature Control Knob
selects the cooking temperatures in 5 o F
increments. The control ranges are:
Oven Mode 200-575 o F (95-300 o C)
Combo Mode 220-575 o F (105-300 o C)
NOTE: Maximum temperature is limited
to 500°F when either the optional probe
or optional hold mode is in use.
6. Optional Features
If the following features are included, please
refer to the control panel guide which was
provided with the unit:
Cook Only Guide: P/N 121084
Programmable: P/N 121042
Probe & Hold: P/N 121072
B. Operating Instructions
1. Steamer Mode
a. If the unit is off, switch on the electric
power by pressing the ON touch pad. (If
the
SERVICE
light comes on when you
turn on the power, see the
Troubleshooting section).
b. If the power is already on, and there is a
number in the time display window, press
the CLEAR touch pad one or more times
to reset the time to zero.
NOTE: You cannot change operating
modes while the timer is running
c. The unit will power up in the mode of
operation in which it was last used.
Because of this, the indicator light for that
mode will be lit. If the unit is not already
in the Steamer Mode, press the STEAM
touch pad. The STEAM light will come
on and the Cook display will go blank.
d. If the unit was recently used in Oven or
Combo Mode, the HOT light may come
on, indicating that the cooking chamber is
too hot for use as a steamer. The unit
can be cooled quickly to the steaming
temperature range by leaving the door
open or following the Fast Cool procedure
described near the end of this section
(Paragraph 4). With the door open the
generator can fill and heat the water to
200 o F, but it cannot produce steam.
WARNING
WHEN YOU OPEN THE DOOR STAY AWAY
FROM ANY STEAM COMING OUT OF THE
UNIT. STEAM CAN CAUSE BURNS.
OM-CC-E and C/2-E
14