background image

OM-BPM-15/30/40E(C,A) (CE) INTERNATIONAL

IMPORTANT - READ FIRST - IMPORTANT

WARNING:  TO PREVENT SHOCKS, ALL APPLIANCES WHETHER GAS OR ELECTRIC, 

MUST BE EARTHED.

 

  ON COMPLETION OF THE INSTALLATION, THESE INSTRUCTIONS SHOULD 

BE LEFT WITH THE ENGINEER-IN-CHARGE FOR REFERENCE DURING 

SERVICING. FURTHER TO THIS, THE USERS INSTRUCTIONS SHOULD 

BE HANDED TO THE USERS AND THE INSTALLER SHOULD INSTRUCT 

THE RESPONSIBLE PERSON(S) IN THE CORRECT OPERATION AND 

MAINTENANCE OF THE APPLIANCE. EMPHASIS SHOULD BE MADE WITH 

REGARD TO SAFE OPERATION OF DRAIN VALVE.

 

  IT IS MOST IMPORTANT THAT THESE INSTRUCTIONS BE CONSULTED 

BEFORE INSTALLING AND COMMISSIONING THE APPLIANCE. FAILURE TO 

COMPLY WITH THE SPECIFIED PROCEDURES MAY RESULT IN DAMAGE OR 

THE NEED FOR A SERVICE CALL.

CAUTION:   SHIPPING STRAPS ARE UNDER TENSION AND CAN SNAP BACK WHEN CUT.
WARNING:  DISCONNECT POWER BEFORE SERVICING. FAILURE TO DISCONNECT 

COULD RESULT IN ELECTROCUTION AND DEATH.

CAUTION:   UNIT WEIGHS 420 TO 560 LB. (191 TO 255 KG). FOR SAFE HANDLING, 

INSTALLER SHOULD OBTAIN HELP AS NEEDED, OR EMPLOY APPROPRIATE 

MATERIALS HANDLING EQUIPMENT (SUCH AS A FORKLIFT, DOLLY, OR 

PALLET JACK) TO REMOVE THE UNIT FROM THE SKID AND MOVE IT TO THE 

PLACE OF INSTALLATION.

WARNING:  INSTALLATION OF THE BRAISING PAN MUST BE DONE BY PERSONNEL 

QUALIFIED TO WORK WITH ELECTRICITY. IMPROPER INSTALLATION CAN 

RESULT IN INJURY TO PERSONNEL AND/OR DAMAGE TO EQUIPMENT.

DANGER:   ELECTRICALLY GROUND THE UNIT AT THE TERMINAL PROVIDED. FAILURE 

TO GROUND UNIT COULD RESULT IN ELECTROCUTION AND DEATH.

CAUTION:   BE SURE ALL OPERATORS READ, UNDERSTAND AND FOLLOW THE 

OPERATING INSTRUCTIONS, CAUTIONS AND SAFETY INSTRUCTIONS 

CONTAINED IN THIS MANUAL.

CAUTION:   THE BRAISING PAN IS NOT INTENDED FOR USE AS A DEEP-FAT FRYER. 

SHALLOW-FRYING IS PERMISSIBLE AS LONG AS THE OIL LEVEL DOES 

NOT EXCEED THE HEIGHT MARK ON THE LOWER REAR WALL (2”, 50MM 

MAXIMUM). SEE THE  USER INSTRUCTIONS SECTION FOR SPECIFIC DETAILS. 

CAUTION:   KEEP FLOORS IN BRAISING PAN WORK AREA CLEAN AND DRY. IF SPILLS 

OCCUR, CLEAN IMMEDIATELY TO AVOID THE DANGER OF SLIPS OR FALLS.

WARNING:   WHEN TILTING BRAISING PAN FOR PRODUCT TRANSFER: 1) USE CONTAINER 

DEEP ENOUGH TO CONTAIN AND MINIMIZE PRODUCT SPLASHING. 2) PLACE 

CONTAINER ON STABLE, FLAT SURFACE, AS CLOSE TO PAN AS POSSIBLE. 

3) STAND TO SIDE OF PAN WHILE POURING — NOT DIRECTLY IN POUR 

PATH OF HOT CONTENTS. 4) RETURN PAN BODY TO LEVEL POSITION AFTER 

CONTAINER IS FILLED OR TRANSFER IS COMPLETE. 5) DO NOT OVERFILL 

CONTAINER, AVOIDING DIRECT SKIN CONTACT WITH HOT CONTAINER AND 

ITS CONTENTS.

INSPECTION & UNPACKING

 

CAUTION:  SHIPPING STRAPS ARE UNDER TENSION AND CAN SNAP BACK WHEN CUT.
CAUTION:  UNIT WEIGHS 420 TO 560 LB (190 TO 255KG). FOR SAFE HANDLING, 

INSTALLER SHOULD OBTAIN HELP AS NEEDED, OR EMPLOY APPROPRIATE 

MATERIALS HANDLING EQUIPMENT (SUCH AS A FORKLIFT, DOLLY, OR 

PALLET JACK) TO REMOVE THE UNIT FROM THE SKID AND MOVE IT TO THE 

PLACE OF INSTALLATION.

The unit will arrive completely assembled, wrapped in protective plastic on a heavy 
skid, in a heavy wooden crate. Immediately upon receipt, inspect the crate for 
damage. Report any apparent shipping damage or an incorrect shipment to the 
delivery agent.
When installation is to begin, get someone to assist in removing the crate. Lift it 
straight up and away from the unit. Write down the model number, serial number, 
and installation date of your unit, and keep this information for future reference. 
Space for these entries is provided at the top of the Service Log in this manual.

WARNING:   DO NOT HEAT EMPTY PAN FOR MORE THAN 5 MINUTES AT A SETTING HIGHER 

THAN 300ºF (149ºC).

WARNING:   IF THE PAN CONTAINS ITEMS IN HOT LIQUIDS SUCH AS SAUCE OR MELTED FAT, 

THEY CAN SLIDE FORWARD SUDDENLY DURING TILTING AND CAUSE THE HOT 

LIQUID TO SPLASH OUT.

WARNING:  AVOID ALL DIRECT CONTACT WITH HOT FOOD PRODUCT OR WATER IN THE 

PAN. DIRECT CONTACT COULD RESULT IN SEVERE BURNS.

WARNING:  IT IS RECOMMENDED THAT WATER AND SOLUTIONS BE KEPT OUT OF 

CONTROLS. DO NOT USE WATER JET SPRAY, HIGH PRESSURE HOSE OR STEAM 

DIRECTLY ON THE CONTROL CONSOLE AND ELECTRICAL CONNECTIONS. 

CAUTION:   MOST CLEANERS ARE HARMFUL TO THE SKIN, EYES, MUCOUS MEMBRANES 

AND CLOTHING. PRECAUTIONS SHOULD BE TAKEN TO WEAR RUBBER GLOVES, 

GOGGLES OR FACE SHIELD AND PROTECTIVE CLOTHING. CAREFULLY READ THE 

WARNINGS AND FOLLOW THE DIRECTIONS ON THE LABEL OF THE CLEANER 

TO BE USED. FAILURE TO DISCONNECT COULD RESULT IN ELECTROCUTION 

AND DEATH.

WARNING:   BEFORE REPLACING ANY PARTS, DISCONNECT THE UNIT FROM THE ELECTRIC 

POWER SUPPLY.

CAUTION:   USE OF ANY REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY 

AUTHORIZED DISTRIBUTORS CAN CAUSE INJURY TO THE OPERATOR AND 

DAMAGE TO THE EQUIPMENT AND WILL VOID ALL WARRANTIES.

IMPORTANT:  SERVICE PERFORMED BY OTHER THAN GROEN AUTHORIZED SERVICE AGENT 

WILL VOID ALL WARRANTIES.

IMPORTANT: THIS APPLIANCE IS MARKED “CE” ON THE BASIS OF COMPLIANCE WITH EMC AND 

LOW VOLTAGE DIRECTIVE.

WARNING:  THIS UNIT IS INTENDED FOR USE IN THE COMMERCIAL HEATING, COOKING AND 

HOLDING OF WATER AND FOOD PRODUCTS, PER THE INSTRUCTIONS CONTAINED 

IN THIS MANUAL. THIS EQUIPMENT IS NOT FOR CONTINUOUS MASS PRODUCTION 

OF FOOD PRODUCTS OR ANY OTHER USE COULD RESULT IN SERIOUS PERSONAL 

INJURY OR DAMAGE TO THE EQUIPMENT AND WILL VOID WARRANTY.

WARNING:  WHEN OPENING TANGENT DRAW-OFF (TDO) VALVE FOR PRODUCT TRANSFER:
 

  1) USE CONTAINER DEEP ENOUGH TO CONTAIN AND MINIMIZE PRODUCT SPLASHING. 

 

  2) PLACE CONTAINER ON STABLE, FLAT SURFACE, AS CLOSE TO UNIT AS POSSIBLE.

 

  3) DO NOT OVER FILL CONTAINER. AVOID DIRECT SKIN CONTACT WITH HOT 

CONTAINER AND ITS CONTENTS.

CAUTION:   THIS APPLIANCE IS NOT TO BE USED BY PERSONS (INCLUDING CHILDREN) 

WITH REDUCED PHYSICAL, SENSORY or MENTAL CAPABILITIES, OR LACK OF 

EXPERIENCE AND KNOWLEDGE, UNLESS THEY ARE SUPERVISED OR GIVEN 

PROPER INSTRUCTIONS.

CAUTION:   CHILDREN SUPERVISED ARE NOT TO PLAY WITH THIS APPLIANCE.
CAUTION:   CLEANING AND USER MAINTENANCE SHALL NOT BE MADE BY CHILDREN 

WITHOUT SUPERVISION.

7.   Steamer pan carrier
8.   Pouring lip strainer
9.   Strainer for 2” (51 mm) TDO valve

Cut the straps holding the unit on the skid, and lift the unit straight up off the skid.
The unit ships strapped to a skid and crated. (Shown is a 40-gallon (151 lites) model 
with optional 2” (51 mm) tangent draw-off).

Adjustable Bullet Feet

One Piece Cover

IPX6 Water Wash-
Down Rated Control 
Console

Power 
Switch

Indicator 
Light

Manual Tilt 
Handwheel

Standard Faucet 
Bracket

2” Tangent Draw-Off

Содержание BPM-15EC/EA













Отзывы: