Grizzly T23092, Руководство пользователя

Страница: 15 / 20

Model T23092 (Mfd. Since 04/11) -13
-
5. Rinse these parts thoroughly in solvent,
then dry with compressed air or let air
dry.
Note: If small holes in atomizing cap
become blocked, soak cap in clean
solvent. If blockage still exists, clear
blockage with a small needle, taking
great care to not enlarge or damage
the hole. Damage to hole will create a
disrupted spray pattern.
6. Use an old tooth brush and solvent to
clean inner orifice and other hard-to-
reach areas on outside of gun body.
7. Wipe gun body dry with a lint-free shop
towel.
DO NOT soak spray gun body in sol-
vent. Prolonged exposure to solvent
will rapidly deteriorate spray gun
washers and seals.
Lubrication
Lubricate the following areas shown in
Figure 17 with a non-silicone spray gun
lubricant after each cleaning.
A. Fluid Control Knob
B. Pattern Control
C. Air Valve Packing
D. Atomizing Cap Threads
E. Trigger Pin
Allow the lubricant to coat the threads and
run into the gun body to lubricate all the
moving parts and seals.
Figure 17. Lubrication locations.
D C
A
B
E