-4-
T10096 Taper Attachment
18. Liberally apply drops of oil at locations shown
in
Figure 14.
12. Use a 5mm hex wrench to secure slide block
to end cap with two previously removed cap
screws (see
Figure 11).
Note: Make sure the top of both slide and
end cap surfaces are flush with one another
after tightening the cap screws (see
Figure 11).
17. Use a 4mm hex wrench to snug slide block
set screw so brass plug is slightly preloaded
against pivot pin (see
Figure 13).
Tip: To make the following steps easier,
remove the taper attachment body from the
dovetail slide.
13. Make sure brass plug is still inside slide block.
14. With help of assistant, raise and align taper
attachment body, so slide block drops into
slot evenly (see
Figure 12).
15. Use
25
⁄
64
" or 10mm transfer punch to locate
holes to be drilled and tapped for mounting
attachment (see
Figure 12). Once holes
have been marked, drill with (Q) drill bit and
tap them M10 x 1.5.
Figure 12. Taper attachment installation.
Figure 13. Pin adjustment.
Pivot Pin
Figure 14. Setup lubrication locations.
16. Reconnect taper attachment body to slide.
Raise and align taper attachment assembly,
so pivot pin slides into pin bore in slide block.
Use 8mm hex wrench to secure taper attach-
ment to carriage face.
Figure 11. Slide block installation.
End Cap
Slide
Block
