T10096 Taper Attachment
-3-
7. Use a 4mm hex wrench to loosen slide block
set screw (see
Figure 7).
Figure 7. Slide block removal.
Figure 9. Slide block end-cap removal.
8. Lift out slide block without losing brass anti-
score plug (see
Figure 8).
10. Use a 5mm hex wrench to remove two cap
screws and slide block end cap (see
Figure
9).
11. Oil and install bearings and races onto lead-
screw in order shown in
Figure 10. Finger-
tighten first 17mm hex nut onto leadscrew
until bearings are slightly preloaded, then
lock in place with second nut. Make sure slide
block end cap has no lash or end play.
9. Apply a dab of multipurpose grease to brass
plug to prevent it from falling out when han-
dling slide block.
Note: This brass plug prevents the set screw
from scoring the main pivot pin when the
taper attachment is being used.
Figure 8. Slide block brass anti-score plug.
Brass
Anti-Score
Plug
Figure 10. Slide block end-cap installation.
Hex Nuts
Inner
Bearings
Slide Block
End Cap
Bearing
Cap
