Grizzly G1037Z, Инструкция по эксплуатации

Страница: 28 / 52

-26-
To perform moulding operations:
1. Plane stock to within 1 ⁄
16
" of the final thick-
ness. Cut the width to within 1 ⁄
8
" of the final
profile if both edges are trimmed by the
knives. Cut to the final width if only the face
is profiled.
2. Align the fence rails with the edges of the
profile knives.
3. Turn the planer/moulder ON. Stand to the
side and feed a test piece into the
planer/moulder. Note—
Always plane WITH
the grain of the wood.
4. Raise the table until the test piece feeds
smoothly into the planer/moulder.
5.
Support the infeed end of the board until half
of the board has been fed into the
planer/moulder, then walk around to the out-
feed side and support the other end of the
board.
6.
Run all the moulding through the
planer/moulder at this table height.
7. Raise the table and run all the moulding
through the planer/moulder again. You
should be able to cut the profile in 2-3 pass-
es depending on the type of wood and the
profile of the cutter.
Always stand to one side of the machine to
avoid kickback. Always wear proper eye
protection.
Removing more than 1 ⁄
8
" off the overall pro-
file of the moulding can break the knives,
resulting in serious damage or injury.
Components and Hardware Needed: Qty
Fence Rail Material (Not included) ..................2
Tools Needed:
C-Clamps (Not included)....................................4
To perform edge moulding operations:
1. Disconnect the machine from the power
source!
2.
Build wooden fence rails that are
3
⁄
4
" shorter
than the work piece and the same length as
the work table as shown in
Figure 23 .
Figure 23. Edge moulding fences.
3. Raise the table until a knife that is at bottom
dead center is below the height of the wood-
en fence rails.
4. Align the fence rails to the knives by sliding
the wooden fence rails against the knife edge
with the metal fence rails. Tighten the lock
knob on the metal fence rails.
5. Clamp the wooden fence rails to the table
with C-clamps, or screw the wooden fence
rails to the bedboard.
6. Adjust the feed rollers as described in steps
15-17 on page 25.
7. Operate as described in the Moulding sec-
tion.
G1037Z 13" Planer/Moulder
Edge Moulding Moulding