Grizzly G1037Z, Инструкция по эксплуатации

Страница: 27 / 52

G1037Z 13" Planer/Moulder -25-
Figure 22. Using the orange “L” gauge.
11. Tighten the gib set screws uniformly just
enough to keep the moulding knives from
moving.
12. Rotate the cutterhead and repeat steps 7-11
for the other two knives. Set the knives so
they butt up against the orange “L” gauge.
13. Tighten all the gibs in each cutterhead slot 1 ⁄
2
turn. Repeat until all the gibs are tight.
14. Check the spring pressure. The nut called
out in
Figure 22 should be no more than 4
threads from the top of the threaded rod.
15. Rotate the knives to face down and raise the
table until
1 ⁄
3
of the knife profile covers the
end of the stock.
16. Loosen the lock nuts and uniformly rotate the
infeed roller adjustment screws until the
infeed roller comes into contact with the
stock.
17. Adjust the outfeed roller adjustment screw
and turn the table height handle a
1 ⁄
2
turn to
set the preload.
18. Re-install the dust collection assembly.
19. Run the machine for five minutes without
moulding any stock. Re-tighten the gibs.
Spring Pressure Adjustment Nut
“L” Gauge
Lock Nut
Infeed Roller Adjustment Screw
Figure 20. Loosening the gibs.
Figure 21. Cutterhead and knives
6. Use the brass drift or a small piece of wood
to tap the gibs down into the cutterhead slot
as shown in
Figure 20.
7. For smaller knife sets only remove the center
spacers. For larger knife sets remove the
gibs, spacers and planer knives. Note—
The
planer knives remain in place when using
knives under 2".
See Figure 21 .
10. Attach the orange “L” gauge to the top of the
planer as shown in
Figure 22 . Adjust it to
touch the edge of the moulding knife and
tighten the hex bolt.
Moulding Knives
Planer Knives
8. Replace the center spacers with the small
knives and tighten the set screws on the
spacer gibs. With the larger knives, use the
gibs included with the knife set.
9. Make sure the knives are set to the bot-
tom of the cutterhead slot and face the
direction shown in Figure 21.