Grizzly G1037Z, Инструкция по эксплуатации

Страница: 10 / 52

-8- G1037Z 13" Planer/Moulder
Electrocution or a fire
can result if the machine
is not grounded correct-
ly. Make sure all electri-
cal circuits are ground-
ed. DO NOT use the
machine if it is not
grounded.
Because of the high amperage draw from this
machine, we do not recommend the use of exten-
sion cords. Instead, position your equipment near
installed wiring to eliminate the need for exten-
sion cords.
NOTICE
The wire on the power cord with green or
green and yellow striped insulation is the
grounding conductor.
In the event of an electrical short, grounding
reduces the risk of electric shock by providing a
path of least resistance to disperse electric cur-
rent. This tool is equipped with a power cord that
has an equipment-grounding prong. The outlet
must be properly installed and grounded in accor-
dance with all local codes and ordinances.
The motor must be rewired to handle the 220V
power source. The correct wiring configuration
can be found in
Figure 2
, as well as on the inside
of the motor wire cover.
Always check to see if the wires in your circuit are
capable of handling the amperage draw from
your machine, as well as any other machines that
could be operating on the same circuit. If you are
unsure, consult a qualified electrician.
If the circuit breaker trips or the fuse blows regu-
larly, your machine may be operating on a circuit
that is close to its amperage draw capacity.
However, if an unusual amperage draw does not
exist and a power failure still occurs, contact a
qualified electrician.
Figure 2. 220V wiring diagram.
This procedure takes moderate electrical skill and
the rewiring job should be inspected by a licensed
electrician before turning the machine
ON .
Rewiring To 220V
Extension Cords
Grounding
Circuit Capacity