Grizzly G0936, Руководство пользователя

Страница: 18 / 52

-16-
Model G0936 (Mfd. Since 06/21)
Figure 10. Dust hose attached to dust port.
Dust Collection
To connect dust collection system to machine:
1. Fit 4" dust hose over dust port, as shown in
Figure 10, and secure in place with hose
clamp.
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON to verify motor operation,
then turn machine OFF. A correctly operat-
ing machine will run smoothly with little or no
vibration or rubbing noises.
— If machine runs smoothly, congratulations,
the Test Run is complete!
— If machine does not run smoothly, imme-
diately turn machine OFF and call Tech
Support for help.
The Test Run consists of verifying the following: 1)
The motor powers up and runs correctly.