Grizzly G0889, Руководство пользователя

Страница: 30 / 56

-28-
Model G0889/G0889Z (Mfd. Since 12/18)
3. Install gib over knife, and slightly tighten gib
screws, starting at middle and working your
way to ends by alternating left and right, as
shown in
Figure 24.
4. Press safety latch to disengage cutterhead
lock (see Figure 22), then carefully rotate
cutterhead approximately ¼-turn. Release
safety latch and continue rotating cutterhead
until next knife slot is exposed and safety
latch again engages.
5. Repeat Steps 2–3 for remaining knives, then
replace dust hood.
1 2 3 4 5 6
Figure 24. Gib screw tightening sequence.
Figure 23. Example of installing knife with
magnet.
Beveled Edge Up
Installing Knives
1. DISCONNECT MACHINE FROM POWER!
2. Using included magnets, align knife with two
pins on cutterhead. Be sure knife is oriented
with beveled edge up, as shown in
Figure 23.
5. Press safety latch to disengage cutterhead
lock (see Figure 22), then carefully rotate
cutterhead approximately ¼-turn. Release
safety latch and continue rotating cutterhead
until next knife slot is exposed and safety
latch again engages.
6. Repeat Steps 3–4 to remove remaining
knives.
Figure 22. Disengaging cutterhead lock.
Cutterhead
Safety Latch
Inspecting Cutterhead, Gib, and Knives
1. DISCONNECT MACHINE FROM POWER!
2. Carefully clean the cutterhead with a rag, and
with a flashlight inspect the following:
• Make sure the threaded screw holes do
not contain wood material or sawdust.
• Make sure that the hex socket and the
threads of all cap screws are in good con-
dition. Replace if questionable.
• Make sure any resin or glue buildup
on the cutterhead, gib, and knives is
removed so the knife and gib will sit flat
on the cutterhead.
• Make sure the knives are free of cracks.
If any cracks exist, replace both knives.