Grizzly G0889, Руководство пользователя

Страница: 27 / 56

Model G0889/G0889Z (Mfd. Since 12/18)
-25-
Feeding Workpiece
The feed rate on this planer is automatically set
at 26 FPM. Infeed and outfeed rollers move the
workpiece through the planer while keeping it
firmly against the table and providing a consistent
rate of movement.
To feed workpiece into planer:
1. Place workpiece on table with side to be
planed facing up toward cutterhead.
Note: Boards more than 24" long should be
supported on both sides of planer.
2. Lower cutterhead until depth bar (see Figure
18) just touches workpiece.
Note: The cutterhead elevation scale does not
provide a precise measurement and should only
be used for approximate measurements. If pre-
cise workpiece thicknesses are needed, use
calipers to ensure your workpieces meet your
standards.
Figure 16. Positioning elevation scale.
Red Arrow
Scale
Elevation Scale
The elevation scale (see
Figure 16) on the right-
hand side panel at the front of the machine shows
workpiece thickness after it leaves the planer. The
thickness measurement is indicated by the top
edge of the red arrow.
Depth Stop Dial
The depth stop dial (see
Figure 17) on the right-
hand side of the machine allows for pre-set cut
depth for consistent repeat planing. Workpiece
thickness is indicated by the red arrow on the
depth dial pointing to the height scale.
To adjust the dial, rotate the cutterhead elevation
crank to raise the cutterhead assembly, rotate
the dial to the preferred depth, then lower the
cutterhead assembly until it gently rests on the
depth stop.
Figure 17. Depth stop dial and scale.
Scale
Depth
Stop
Dial
Figure 18. Basic planing operation setup.
Infeed
Outfeed
Depth
Bar
Note: Any time you switch directions with
cutterhead elevation handle, there will be a
small amount of backlash—so the first full
crank of the handle after switching directions
will be slightly less than
1
⁄
16
". However, as
long as you move the handle in the same
direction during operation, backlash will not
be a factor.