Grizzly G0811, Руководство пользователя

Страница: 34 / 68

-32-
Model G0811 (Mfd. Since 02/16)
The speed at which the saw blade will cut through
a workpiece is controlled by blade type, feed rate,
and feed pressure. The feed rate is controlled by
the feed rate dial on the control panel.
Note: If a lubricant is used on the cut, the feed
rate can be increased by approximately 15%.
Feed Rate
Note: This spring adjustment is an initial set-
ting. Depending on cutting circumstances,
you will have to fine-tune the feed pressure
with this adjustment. Increasing the spring
tension will reduce the feed pressure.
3. Clamp workpiece in vise.
4. Close feed rate dial to lock headstock and
blade a few inches above workpiece.
5. With correct saw blade and blade speed
selected, turn saw and coolant pump
ON.
6. Open feed rate dial (see Figure 37), then
slowly rotate dial clockwise to a slow feed
rate until saw begins to cut workpiece.
7. Observe chips that exit cut, and increase or
decrease feed rate according to chip charac-
teristics indicated in
Chip Inspection Chart
on Page 31.
Tools Needed Qty
Open-End Wrench 14mm .................................. 1
1. Raise headstock to highest position.
2. Set Feed Rate Dial shown in Figure 37 to
desired feed rate—"0" (slowest), "9" (fastest).
Setting Feed Rate
Figure 38. Feed pressure controls.
Adjustment Nut
Tension Spring
1. Raise headstock to highest position to remove
tension on tension spring (see Figure 38).
2. Tighten adjustment nut (see Figure 38)
enough to remove tension spring play but not
enough to apply tension to spring.
Setting Feed Pressure
Figure 37. Location of feed rate dial.
Feed Rate Dial
The Model G0811 is equipped with a work stop
that can be used to quickly position the workpiece
during a repetitive cutting operation. Adjust the
work stop as needed, then tighten the set screw
and knob to lock it in place, as shown in
Figure 39.
Work Stop
Figure 39. Setting work stop to support repetitive
cutting operation.
Tool Needed Qty
Hex Wrench 3mm .............................................. 1
Knob
Set Screw