Grizzly G0803, Руководство пользователя, Страница: 45 / 60

G0803 (Mfd. Since 09/15)
-43-
Replacing Belt
Tools Needed Qty
Hex Wrench 6mm .............................................. 1
Retaining Ring Pliers ......................................... 1
Replacement Belt (Part No. P0803048) ............ 1
To replace the belt:
1. DISCONNECT MACHINE FROM POWER!
2. Put on heavy leather gloves and remove
blade from machine (refer to Changing
Blade on Page 31).
3. Loosen motor mount cap screws (see Figure
51 on Page 42).
4. Pivot motor to the left (as viewed from back
of bandsaw) to release belt tension.
5. Open lower wheel cover and remove belt
from motor pulley.
To ensure optimum power transmission from the
motor to the blade, the belt must be in good condi-
tion and be properly tensioned.
Replace the belt if it shows signs of cracking, fray-
ing, and excessive wear.
7. Install new belt on both pulleys, and then re-
install wheel and retaining ring.
8. Properly tension belt, as instructed in Belt
Tension on Page 42.
9. Replace blade, properly track and tension
it (see
Pages 17 and 20), and then adjust
guide and support bearings.
6. Remove external retaining ring from lower
wheel shaft (see Figure 52) and remove
lower wheel.
Figure 52. Belt change components inside lower
wheel cover.
Belt
External
Retaining Ring