Grizzly G0767, Руководство пользователя

Страница: 33 / 48

Model G0767 (Mfd. Since 1/14)
-31-
Adjusting Profile
Roller Height
To produce an accurate notch, the center of the
profile roller must be even with the center of the
tube when mounted in the vise (see
Figure 39).
The correct height of the profile roller depends on
the height of the roller support bracket. This was
set properly at the factory. However, if you deter-
mine that the center of the profile roller is not even
with the center of the tube when mounted in the
vise, perform the following procedure to adjust it.
Tool Needed Qty
Hex Wrench 8mm .............................................. 1
To adjust roller support bracket height:
1. DISCONNECT MACHINE FROM POWER!
2. Properly mount a tube in vise.
3. Loosen the two roller support bracket cap
screws shown in
Figure 40.
4. Move profile roller up or down to center pro-
file roller with center of tube.
5. Retighten the two cap screws loosened in
Step 3.
Figure 40. Location of roller support bracket cap
screws.
Cap Screws
Figure 39. Profile roller and tube even with each
other.
Roller Support
Bracket