Grizzly G0762, Руководство пользователя

Страница: 35 / 60

Model G0762 (Mfd. Since 5/14)
-33-
Ball Oilers
Lube Type ...Model T23963 or ISO 32 Equivalent
Lube Amount ..................................... 1–2 Pumps
Lubrication Frequency ........... 8 hrs. of Operation
Proper lubrication of the handwheel ball oilers
shown in
Figure 40 is done with a pump-type oil
can that has a plastic or rubberized cone tip (see
Page 30 for offerings from Grizzly). We do not
recommend using metal needle or lance tips, as
they can push the ball too far into the oiler, break
the spring seat, and lodge the ball in the oil galley.
Push the tip of the oil can nozzle against the ball
oiler to create a hydraulic seal, then pump the oil
can once or twice. If you see sludge and contami-
nants coming out of the lubrication area, continue
pumping the oil can until the oil runs clear. When
finished, wipe away the excess oil.
Figure 40. Location of handwheel ball oilers.
Ball Oilers
Table & Column Ways
Lube Type .. Model SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........... 8 hrs. of Operation
Using a 4mm hex wrench, disconnect one side
of the column way cover, then move the table
and headstock to access the entire length of the
table and column ways for this procedure (see
Figure 41).
Note: Each sliding component has two dovetail
ways—one on each side of the component.
Clean the ways with mineral spirits and shop
rags. When dry, apply a liberal coat of lubricant,
then move the sliding components through their
full paths a few times to evenly distribute the oil.
Re-install the column way cover.
Figure 41. Location of table and column ways.
Table Ways
Column Way
(1 of 2)
Column Way
Cover