Grizzly G0762, Руководство пользователя

Страница: 29 / 60

Model G0762 (Mfd. Since 5/14)
-27-
Figure 28. Table locks and limit stops.
Limit Stops
X-Axis
Table Locks
X-Axis Power Feed
Your mill/drill is equipped with a power feed unit
for X-axis table movement.
Note: The power feed must be connected to an
independent, grounded 110V power supply to
operate.
Tool Needed Qty
Hex Wrench 5mm .............................................. 1
To operate X-axis power feed:
1. Loosen both X-axis table locks shown in
Figure 28.
2. Position limit stops along table to confine the
distance you want table to travel.
3. Move power feed directional lever (see
Figure 29) to center or neutral position. This
will prevent table movement when unit is con-
nected to power.
Figure 29. X-axis power feed controls.
Directional
Lever
ON/OFF
Switch
Speed Dial
4. Connect power feed unit to a grounded 110V
power source.
5. Rotate speed dial to “0” and use directional
lever to select direction of table movement.
6. Flip ON/OFF switch up to turn power feed
ON.
7. Adjust speed dial to move table at required
feed rate for your operation.
Note: Power feed rates are difficult to pre-
cisely adjust. We recommend that you exper-
iment with different dial settings to find feed
rates that best work for you operation.
8. When finished, leave directional lever in
center or neutral position, and flip ON/OFF
switch down to turn power feed
OFF.
Installing/Removing
Tooling
The Model G0762 includes the following spindle
tools (see
Figure 30):
A. 1–13mm Drill Chuck w/R-8 x B16 Arbor.
Joined with the drill chuck.
B. R-8 x MT#3 Spindle Sleeve. Used for MT#3
tools and will accommodate tools with a tang.
It also has a drift key slot for tool removal.
C. MT#3 x MT#2 Spindle Sleeve. Used with the
R-8 x MT#3 spindle sleeve for MT#2 tools
and has a drift key slot for tool removal.
Figure 30. Spindle tools and arbor included with
Model G0762.
A
B
C
Drift Key Slot
Alignment Slot