Grizzly G0761, Руководство пользователя, Страница: 33 / 56

Model G0761 (Mfd. Since 10/13)
-31-
Headstock
lube type ...Model t23962 or iso 68 equivalent
lube Amount .............................................3
1
⁄
4
qt.
Check/Add Frequency ........... 8 hrs. of operation
Change Frequency ................................ Annually
the headstock has the proper amount of oil when
the sight glass shown in
Figure 36 is halfway full.
Tool Needed Qty
hex Wrench 8mm .............................................. 1
To change headstock oil:
1. run spindle at 670 rpM for approximately 10
minutes to warm oil.
2. disConneCt MAChine FroM poWer!
3. remove fill plug (see Figure 37).
4. place a 1-gallon or larger drain pan on table
under headstock.
5. remove drain plug (see Figure 38) from
underneath headstock and allow oil to drain
into pan.
Follow federal, state, and local require-
ments for proper disposal of used oil.
6. replace drain plug.
7. Add oil until sight glass is halfway full, then
replace fill plug.
8. Clean up any spilled oil to reduce slipping
hazards.
Figure 36. headstock oil sight glass.
sight
glass
Figure 37. headstock oil fill plug.
Fill
plug
Figure 38. headstock drain plug
(headstock tilted 90° for clarity).
drain
plug