Grizzly G0686, Руководство пользователя

Страница: 19 / 44

Model G0686 (Mfd. Since 01/15)
-17-
7. Loosen the jig height lock lever, thread the jig
set screw back into the pivot base, then tight-
en the lock lever again to hold the assembly
in place (see
Figure 9).
Figure 11. Jig attached to the pivot base.
Hex Bolt
& Flat Washer
Set
Screw
5. Align the positioning pin of the jig with the
hole in the pivot base, as shown in Figure 10,
then insert the pin and lay the jig base flat on
the pivot base.
6. To secure the jig assembly, install the hex
bolt and flat washer removed in
Step 2
through the jig base and into the pivot base,
as shown in
Figure 11.
Test Run
To test run the machine:
1. Make sure all tools and objects used during
setup are cleared away from the machine.
2. Use the carriage handwheel to make sure the
jig is positioned safely away from the grinding
wheel.
3. Connect the machine to power and turn it
ON.
4. Listen to and watch for abnormal noises or
actions. The machine should run smoothly
with little or no vibration or rubbing noises.
— Strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
5. Turn the machine OFF.
The Test Run consists of verifying the following: 1)
The motor powers up and runs correctly.
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.