-20-
g0664 heavy duty Metal-Cutting Bandsaw
to ensure your safety and to prevent damage to
the machine, you must adjust the blade tension
before the
Test Run.
Blade tension (
page 36) is not set at the factory
to prevent unnecessary stress on the blade dur-
ing shipping. if the
Test Run is performed without
first properly tensioning the blade, the blade may
come off, resulting in personal injury or damage to
the blade or machine.
to properly tension the blade, turn the blade ten-
sion handwheel until the blade tension gauge
reads between 25,000 and 28,000 psi (
page
36).
Required
Adjustments
4. Flip the completed roller tables onto their feet
and place them on either side of the saw, as
shown in
figure 16.
figure 16.
Positioning roller tables.
5. place a long straightedge across the saw
table and roller tables and adjust the legs so
that the roller tables are even with the saw
table.
6. tighten all (16) leg cap screws.
Coolant Reservoir
Cover/Catch Tray
figure 17. Coolant reservoir cover/catch tray.
screws
reservoir Cover tray
attach the coolant reservoir cover/catch tray to the
machine with the four M6-1 x 10 button head cap
screws (
figure 17).
